EURASOL Primer Plus SK adhesion primer
UNDRCOAT-EURASOL-PRIMER-PLUS-SK-1000G
Register now and access more than 125,000 products
Self-adhesive formula significantly increases adhesion
Strengthens fibrous and porous surfaces for secure bonding with adhesive tape
Environmentally friendly and easy to use
- Odourless, does not release toxic substances and solvents
- Practical dispenser bottle for easy and clean application
Good material compatibility
Does not damage adjacent surfaces
Good resistance to water and heat when fully dry
Quick-drying
This product is classified in accordance with EMICODE® (EC1 Plus). EMICODE® is an independent labelling system for low-emission products, based on specified test methods and limit values.
Thickened Eurasol Primer Plus can be diluted with water. Eurasol Primer Plus SK can be cleaned with water while fresh; when hardened it can generally only be removed mechanically.
Drying time may vary according to substrate material (absorbent, non-absorbent, damp etc.) and temperature. The primer must be protected against moisture until it is fully hardened.
Once fully hardened, the structure must be covered e.g. with a water vapour-permeable tarpaulin for more than 16 hours in the event of prolonged rain/snow.
Avoid exposure to continuous/standing moisture.
Application on frozen, ice-free surfaces is possible, provided the climatic conditions reach/exceed +5 °C on that working day.
Datasheets(X)
Solvent-free primer for improved adhesion of EURASOL, butyl and bitumen adhesive tapes to mineral and absorbent surfaces.
For use with:
- Adhesive bonding on soft wood fibre, wooden, cement and gypsum fibreboard panels
- Adhesive bonding of wooden bases to concrete
- Window sealing tapes with butyl strips on reveal surface
Shake before application. Apply evenly with a brush or lacquer roller to a dry, grease- and dust-free surface. Treat highly porous surfaces twice if necessary. Allow the applied film to dry until it is transparent before pressing on the adhesive tape.
Chemical basis | Acrylate polymer dispersion |
Colour after curing | Transparent |
Weight of content | 1000 g |
Smell/fragrance | Characteristic |
Density | 1.02 g/cm³ |
Density conditions | at 20°C, EN 542 |
Min. application quantity in surface bonding | 100 g/m² |
Application quantity conditions | depending on the absorbency of the surface |
Drying time | 14 min |
Solvent-free | Yes |
VOC concentration (CH) | 0 % |
Min. processing temperature | 5 °C |
Min. surface processing temperature | -10 °C |
Shelf life from production | 12 Month |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!